ideal for
• windows • doors • cladding • fascia boards • all external woodwork
unique qualities
• VOC free • water repellent • does not blister or peel • very high solids • UV protective filters • microporous • biocides protect against algae, mildew and fungal attack
at a glance product info
interior
exterior
water resistant
UV filter protection
microporous
biocide boost
high particle content
does not blister or peel
available in: 500ml • 1 litre • 2.5 litre
drying time: Touch dry 1-2 hours • recoat time: 12 hours. Low temperature/high humidity can increase drying time. • coverage: 16-20 square metres per litre
application and advice
preparation
New timber should be clean, non-oily and thoroughly dry. Remove all old coatings to bare wood. If the timber is not pressure treated apply an appropriate wood preservative.
application
For best results use a clean, lint free cloth. Apply a thin even coat in the direction of the grain, work the oil into the grain of the wood ensuring complete saturation of the timber. When dry (minimum 12 hours), apply a second coat. Do not apply below 5° C.
caution
Always apply to a test area before starting work. Timbers containing high natural oils, e.g. Teak and Iroko, may inhibit drying and cause impaired adhesion. Wiping surface with methylated spirit will assist adhesion. Application rollers, sponges and pads, or clothes soaked in this product, may spontaneously combust if left. Dispose of after soaking in water.
Wear a suitable face mask if dry sanding.
storage
Protect from extremes of temperature during storage and application.
health, safety and the environment
Keep out the reach of children. If swallowed, seek medical advice immediately and show this container or label. Use only in well ventilated areas.
Do not empty into drains, dispose of this material and its container at hazardous or special waste collection point.